Product features
Solitary strand sprocket with a single group of teeth around the circumference for applications where a single chain may support the torque and load
Pitch of 3/4 inch for size 60 chains
Sprocket bore and hub with QD fittings for inserting and locking bushings into place
Type B sprocket with a hub projection using one side to accommodate numerous kinds of bushings to greatly help prevent sprocket from slipping on the shaft
Sprocket teeth assist in preventing slipping and binding to avoid power loss in assemblies
Product description
This Tsubaki roller chain sprocket includes a 3/4-inch pitch, fits size 60 chains, and is single strand with one set of teeth around its circumference for use with single strand chains. It is a sort B sprocket with a hub projection encircling the bore using one side, and both the hub and bore possess Quick-Disconnect (QD) fittings for inserting and locking into place different QD bushings based on the diameter of the shaft. The teeth of the sprocket help prevent slipping and binding in order to avoid power reduction in assemblies. It fulfills International Firm for Standardization (ISO) 9001 for quality assurance. This single strand roller chain sprocket is usually ideal for use in a broad range of applications including light to moderate loads and ongoing, high-cycle operations, including vehicle transmission systems, building and agricultural apparatus, conveyors, and factory manufacturing and assembly lines, amongst others.
A roller chain sprocket is a thin wheel with deep, uniformly spaced the teeth ringing its circumference. The length from the peak of one tooth to the next is called the pitch, and is commonly measured in 1/8-in . increments. The sprocket transfers power and motion by a roller chain that is threaded over one’s teeth of the sprocket. The alignment of the chain 
with the sprocket’s pitch stops the chain from slipping to ensure that no power is usually lost. In the center of the sprocket may be the bore (hole) for sliding the sprocket onto a shaft, and a bushing or bearing is often suited to the sprocket’s hub to custom-fit the sprocket onto a shaft to carry it firmly in place. A hub is usually a protruding, elevated lip encircling the bore of the sprocket. Sprockets with hubs on both sides are Type C, sprockets with hubs using one part are Type B, and sprockets with no hubs are Type A sprockets. For applications requiring sprockets to be swapped onto shafts of different diameters, a sprocket with a bore large enough to fit all shafts may be used, with the gap between your bore and shaft closed with a bushing or bearing. Roller chain sprockets are found in a broad selection of applications where the drive power of an engine must be transferred into motion, such as in motor vehicles, conveyors, escalators, agricultural, forestry and mining gear, aeronautics, robotics and space exploration, among others.
U.S. Tsubaki Power Tranny manufactures a variety of chains, sprockets, and additional power transmission parts that meet International Business for Standardization (ISO) standards for quality assurance. The company, founded in 1917, is usually headquartered in Wheeling, IL.